|
|
|
| 新聞資訊 / News |
電加熱器英文簡易安裝說明 |
|
電加熱器安裝使用說明
User Manual
1. 本電加熱器為設計的水用電加熱產品，它安裝于水箱上，用于水的加熱。
This type of electric heater is designed for heating water which and installed on the top of water tank.
2. 技術參數 Technical Parameter
功率：1.5~15kw（系列）
Rated Power：1.5～15KW(Series Product)
電壓：200~460Vac（系列）
Rated Voltage : 200～460Vac (Series Product)
壓力：常壓
Pressure: Ordinary
溫度：＜80℃
Temperature: not more than 80℃
3. 加熱水箱上必須裝有溫度傳感器（一般為Pt100）。電加熱器加熱時由電氣控制箱對加熱溫度進行控制，電加熱器才能正常運行。溫度過高，壓力過大都可能釀成事故。
The thermal sensor (ordinary Pt100) must be fixed in the water. Only electric panel box can control the heater to regulate the water temperature. If the temperature or pressure exceeds the threshold level it will give rise to an accident.
4. 電加熱管必須全部浸入水中才能通電加熱。
The electric heat elements must be immerged in water totally before switch on.
5. 通電前應先檢查電加熱器的絕緣電阻，當發(fā)現(xiàn)絕緣電阻急劇降低，應立即進行檢查，找出原因排除后才能通電使用。
The insulate resistance must be checked before use, if the insulate resistance falls down rapidly, it is not allowed to swich on the heater before the malfunction has been eliminated.
6. 電加熱器必須可靠接地。
The earthing must be connected to the heater.
|
|
|
| [返回] |
|
|